This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
documentation:software:atlas:setup [2016/08/19 15:08] frank_defalco |
documentation:software:atlas:setup [2017/10/17 16:27] anthonysena |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ~~NOTOC~~ | ||
+ | |||
===== ATLAS Setup ===== | ===== ATLAS Setup ===== | ||
Line 6: | Line 8: | ||
=== WebAPI === | === WebAPI === | ||
- | The first prerequisite for ATLAS is to [[documentation:software:webapi:setup|Install the OHDSI WebAPI]] and configure the appropriate sources. The following figure provides an example topology to show the different elements involved in the WebAPI architecture and a visual representation of the [[documentation:software:webapi:source_configuration|source configuration]]. | + | The first prerequisite for ATLAS is to [[documentation:software:webapi:webapi_installation_guide|Install the OHDSI WebAPI]] and [[documentation:software:webapi:source_configuration|configure the appropriate sources]]. |
- | + | ||
- | **Note:** The example above does not represent a physical architecture. The WebAPI configuration allows you to physically and logically segregate these data sources based on the requirements of your environment. | + | |
=== ACHILLES === | === ACHILLES === | ||
- | To use the [[documentation:software:atlas:data-sources|Data Sources]] feature within ATLAS you must first [[documentation:software:achilles|setup and execute ACHILLES]] in your environment. Once you have successfully generated summary statistics and have exported your data to JSON format, you are ready to configure ATLAS to use this information. | + | To use the [[documentation:software:atlas:data-sources|Data Sources]] feature within ATLAS you must first [[documentation:software:achilles|setup and execute ACHILLES]] in your environment. Once you have successfully generated summary statistics, you are ready to configure ATLAS to use this information. |
==== ATLAS Installation ==== | ==== ATLAS Installation ==== | ||
Line 42: | Line 42: | ||
config.services: Edit this array to provide a name for your environment and the URL for the WebAPI that was set up in WebAPI section. | config.services: Edit this array to provide a name for your environment and the URL for the WebAPI that was set up in WebAPI section. | ||
- | config.dataSourcesLocation & config.dataSourcesRoot: If you have set up your CDM statistics (Achilles), these properties should be set to the URL where your CDM statistics resides. In the configuration below, we are using a relative path since we assume you have hosted your CDM statistics on the same web server as ATLAS but under a different directory. | + | config.dataSourcesLocation & config.dataSourcesRoot **//(v1.x of Atlas - these configuration settings are no longer required in v2.0)//**: If you have set up your CDM statistics (Achilles), these properties should be set to the URL where your CDM statistics resides. In the configuration below, we are using a relative path since we assume you have hosted your CDM statistics on the same web server as ATLAS but under a different directory. |
You should now be able to navigate to ATLAS from your web browser. | You should now be able to navigate to ATLAS from your web browser. | ||
Line 49: | Line 49: | ||
+ | ==== ATLAS Installation Archive ==== | ||
+ | [[documentation:software:atlas:archive:atlas_setup_v1_x|ARCHIVE: ATLAS Setup (v2.1 or earlier)]] |